MSF30413 Certificate III in
|Industries:||Construction , Manufacturing|
This qualification describes the skills and knowledge required to perform a range of glass and glazing job roles, including safely manufacturing, processing, moving and installing various types of glass and handling glazing materials and components.
The MSF30413 Certificate III in Glass and Glazing reflects vocational outcomes for those performing glass processing, glazing or architectural glass functions in residential and commercial operations and could include manufacturing, processing, installation and stained glass and leadlighting design. Job roles would be in a defined range of skilled operations, usually within a range of broader related activities involving known routines, methods and procedures, where some discretion and judgement is required in the selection of equipment, services or contingency measures and within known time constraints.
Specialisation is possible in this qualification depending on the electives chosen. A specialisation can be identified on the testamur where a minimum of six (6) elective units of competency are achieved in one of the three elective groups and units chosen must include those marked with ‘#’ in each specialist group:
Where specialisation is achieved, RTOs should identify this as follows:
MSF30413 Certificate III in Glass and Glazing
(specialising in Glass Processing/Glazing/Architectural Stained Glass)
There are no specific licenses that relate to this qualification. However, depending on the state and territory where work is undertaken licensing may relate to this qualification where the candidate is required to work on-site. The licensing requirement will usually involve construction induction training. Where licensing is required the unit CPCCOHS1001A Work safely in the construction industry should be selected. If no licensing requirement exists (e.g. where all work will be off-site) then the unit MSMWHS200 Work safely should be selected
Depending on the jurisdiction, licensing or regulatory requirements may apply to the use of some units in this qualification. Licensing of glazing work applies in Queensland, NSW and South Australia. Local regulations should be checked for details.
(Sourced from Training.gov.au)
* Fee estimate
Smart and Skilled fees are set for the whole qualification. They are not annual fees.
Any fees displayed on this website are estimates only. Contact your chosen training provider to confirm your eligibility and fee.
Apprenticeship and Traineeship qualifications
If you are a NSW apprentice or trainee you may be eligible to undertake the qualification that supports your apprenticeship or traineeship. The fees displayed on this website for these qualifications are based on the standard apprentice or trainee fee. You may be eligible to pay a concession fee or for a fee exemption. Contact your chosen training provider to confirm your eligibility and the fee you will pay.
For further assistance with locating a Smart and Skilled provider, please contact the Customer Support Centre at SmartandSkilled.Enquiries@det.nsw.edu.au or call 1300 772 104.