Back to results
JoT Scholarship

MEM40119 Certificate IV in

Engineering

Full time duration: up to 2 years ­  Your fee estimate*:

This qualification defines the skills and knowledge required for a higher engineering tradesperson within metal, engineering, manufacturing and associated industries.

The skills associated with this qualification are intended to apply to a wide range of engineering work undertaken in the fields of refrigeration and air conditioning, casting and moulding, computer numerically controlled (CNC) programming, fluid power, heavy fabrication, instrumentation, maintenance, plant mechanics, marine electronics, mechatronics, patternmaking, robotics, toolmaking, welding and watch and clock services and repair, including post-trade work.

It provides the skills and knowledge for a person to understand and implement quality control techniques, exercise good interpersonal and communications skills, work from complex instructions and procedures, exercise discretion within the scope of responsibility, perform work under limited supervision either individually or in a team environment, be responsible for assuring the quality of their own work, provide trade guidance and assistance as part of a work team, perform non-trade tasks which are incidental or peripheral to the primary tasks and facilitate the completion of the whole task, inspect products and/or materials for conformity with established operational standards, operate lifting equipment incidental to their work and assists in the provision of training in conjunction with supervisors and trainers.

This qualification may be accessed by direct entry. While there is no qualification entry requirement, it is assumed that the learner is either already a tradesperson with access to structured on and off-the-job training or is an apprentice under an Australian Apprenticeship arrangement. It should not be used as a pre-employment or pre-apprenticeship program. It is specifically designed to cover the skills and knowledge required of workers employed as Engineering/Manufacturing Tradesperson – Special Class Level II as defined in the Manufacturing and Associated Industries and Occupations Award.

No licensing, legislative or certification requirements apply to this qualification at the time of publication. However, in some jurisdictions units in this qualification may require a license. Licensing information is included in the relevant units of competence.

The following additional descriptors are approved for use with this qualification:

  • Casting and Moulding
  • CNC Programming
  • Fluid Power
  • Boilermaking
  • Instrumentation
  • Maintenance
  • Fixed and Mobile Plant Mechanic
  • Mechatronics
  • Patternmaking
  • Refrigeration and Air Conditioning
  • Marine Craft Construction
  • Robotics
  • Sheet Metal
  • Toolmaking
  • Watch and Clock Service and Repair
  • Welding

No other descriptor can be used.

(Sourced from Training.gov.au)

More information

Course details

MEM40119

Filter results by:
Nearest location to

Training provider ­ 
Delivery mode ­ 

* Fee estimate
Smart and Skilled fees are set for the whole qualification. They are not annual fees.
Any fees displayed on this website are estimates only. Contact your chosen training provider to confirm your eligibility and fee.

Apprenticeship and Traineeship qualifications
If you are a NSW apprentice or trainee you may be eligible to undertake the qualification that supports your apprenticeship or traineeship. The fees displayed on this website for these qualifications are based on the standard apprentice or trainee fee. You may be eligible to pay a concession fee or for a fee exemption. Contact your chosen training provider to confirm your eligibility and the fee you will pay.

Important information on eligibility and student fees.